Mazda RX-8

you know you've hit a new low when you become sad and jealous reading about a pair being close and loving together because you would never have something like that

The newest book in the Deephaven Mystery series creeps onto shelves TODAY! There's a chill in the air, a perfect time to explore the dark corners of these illustrated gothic horror novels. Find them wherever you get books!

MXR PHASE 90

Step into the unknown 🍂

Please welcome Perucetus, the new - and largest- known archeoceti.

A whale of enormous proportions. While it's exact size and weight is certainly a matter of heated debates it was no doubt a really big boi. Here a quick sketch of it approaching a time traveler.

DIY Tutorial - Bottle Cap Pins

I was asked to show how i make pins so this is what i do to make a pin from shit around my house. If youre a can tab collector like me, you’ll like this one too. (Ps, in the photo above, mine are a lil scuffed because i wear these on my every day jacket so that can happen too so beware)

Supplies

- Metal bottle cap, you can get those from beer bottles or sodas, usually theyre found on a lot of glass bottled drinks, ive also found them discarded on the road and sidewalks

- Can tab, any works for this really, as long as its not like huge or somethin

- Safety pin, you can use whatever size for this part really, i would think the only issue is if the safety pin is too small. Mine are about an inch

- Pliers, it doesnt have to be needle noses or anythin, just pliers

- Superglue or hot glue, this is entirely optional for makin this more stable

- Paint/paint marker, mod podge/varnish, nail polish and clear nail polish, etc, this is technically optional but thats the stuff you would use to customize said pin

The steps

1.) Use your pliers to flatten down two of the back edges of the bottle cap, if you wanna keep the design upright, do this on either side of the design on your cap.

2.) Bend your can tab slightly in half, very slightly, not too tall.

3.) slide your can tab into the back of the bottle cap vertically, the bent edges should be on the left and right of your tab.

4.) Slide your safety pin with the pin/pointy side facing up into the can tab with either end of the safety pin nesting in the flattened edges from before, you can do this through that middle rung on the tab if you want, i never do.

5.) bend all the edges of your cap down and around the tab in the middle, you can sorta control the shape here if you choose to. Also beware that this might scuff up the front, it typically does for me

6.) Now you have a pin, at this point you can glue it for extra hold on the can tab or the back of the safety pin if you want or you can design the front of the pin with paint or markers, id imagine you could even print a design to glue onto the front if you want a pin with a certain photo but ive never tried it personally.

After that youre done and have the ability to make pins with anything you want on them now !

They had dragon quest IX in this ad too?!

The sponsors for SpongeBob’s “The Clash of Triton” premiere from 12 years ago today

My oil painting of Whiterun from Skyrim! Hope you guys like it!!